• RAYPEX 6


Product Code : HDDT000476

High-tech apex locator with easy touch

Availability: In stock

Add to Wishlist

Bluk Oreder is available

Check the bulk price

Check Cash On Delivery Availability At

Note: COD Available on Order Value of Rs. 500 & Above.

  • HitechdentalDescription
  • HitechdentalPackaging
  • HitechdentalAdditional Information
  • Product information

    How do I read the display?

    As long as the file moves in the coronal and medial section of the root canal, its position is only shown in the full tooth image (upper left in the display).

    As soon as the file moves towards the apical region, the position of the file is additionally shown on the enlarged image in the APEX ZOOM (right in the display).

    Blue bars: the file is approaching the working length position.

    Green to yellow bars correspond to the section of the apical
    constriction up to the apical foramen, i.e. this is the relevant region for determining the working length.

    Red bar: the file tip has reached the apical foramen.

    Red warning dot: the apical foramen has already been exceeded (CAUTION! Overinstrumentation).

    Length determination

    The working length should usually be determined at the third green bar. Since the working length must always be specified in consideration of the respective pathological situation (vital or devital) and in accordance with the personal decision, the working length may however vary between the first green and last yellow bars. You can find detailed information in the RAYPEX 6 Operating Manual, Chapter 7.5.


    Determining the working length can be done both in the customary rinsing solutions as well as in the physiological milieu. Since the rinsing solution used has a small influence on determining the working length, we recommend:

    a) to determine the length in a moist, physiological milieu and/or
    b) to determine the length in a physiological saline solution 0.9% NaCl or low percentage sodium hypochlorite solutions (e.g. 2% NaOCl)

    After electric length determination and setting the stopper, the metric working (in mm) length should be determined with the help of a measuring gauge (e.g. VDW Minifix measuring gauge).

  • .
  • Specification




Authentic Products


Free Shipping


Forgotten Password?

Please enter your email address below. You will receive a link to reset your password.